Shanxi Environmental Protection ignition normal sun, you can point the fires burning, but can not be maintained, and the flame color is red. Check the combustion air blower if there is clogging, feel the effects of combustion exhaust fan, there is not enough wind turbine may be reversed if the reversal is adjusted into line any two swap position. (Liquefied petroleum gas may also cause no net color is red flame Shanxi gas equipment manufacturers, so if you need to replace the liquefied gas can. Gas pressure is too large may also happen, tune in to the pressure between 1 to 1.2 ) When the burner micro pressure gauge normal combustion pressure between 200-400 better. (Depending on the normal combustion burner can prevail) appear flameout alarm: program basis having reset button on the controller 3-8 seconds, the alarm indicator on the controller to be programmed without blinking, if not reset, you need to cut off the burning Machine external power for 10 seconds, then repeat the operation later on, you can reset. Shanxi Environmental Protection Equipment sun burn status monitoring combustion state must be dynamic monitoring, once the flame detector senses the flame signal must be in a very short period of time feedback to the burner, the burner immediately into protective state, and cut off the gas supply. Flame detector test to be able to sense the normal flame signal, neither sensitive nor dull. Because sensitive to fluctuations in the combustion state if prone to malfunction and slow, the feedback signal lags Shanxi flame gas equipment, is not conducive to safe operation. General requirements for flame signal emitted from the flame to the flame detector response time is not more than 0.2 seconds. Burner flame protection in the combustion process, if unexpected flameout, burner into the protected status. Because the furnace is hot. Gas into the prone deflagration, it should be a very short time into the protected status, cut off the gas supply at. Happened to the burner flame from entering the protected state, the response time of the procedure does not require more than one second. High and low gas pressure limit protection stable combustion gas burner has a certain range, allowing only the gas pressure to fluctuate within a certain range. High and low pressure gas limited purpose is to ensure that the flame stability: not from the fire, not the flame is not tempered, while limiting the output of thermal power burner gas equipment distributor in Shanxi, to ensure safe operation of equipment. When the gas pressure is outside this range, you should lock the burner work. Burner designed for general use gas pressure switch sensing pressure signal and the output switch signal to control the burner of the corresponding work. Methanol Burner said there were three ways to solve the leakage problem furnace: First time to strengthen hair and hair volume pre Shanxi gas equipment suppliers, blowing or dilution gas furnace; the second is the use of two gas line solenoid valve tandem structure, improve system security; the third is the use of pipeline leakage detection device before the ignition of the gas pipeline to detect gas leaks if a certain amount of work that is locked burner. Shanxi Gas Equipment picture, the sun can burn machine (certified), Shanxi, Shanxi Rising gas equipment provided by the Environmental Protection Equipment Co., Ltd. Shanxi Environmental Protection Equipment Co., Ltd. Rising Sun (www.sxxrn.com) is Taiyuan, leading boiler softened water treatment equipment, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. In the sun can burn unit leadership with the staff warmly welcome all inquiries negotiations to create the sun can burn machine a better future.