Ignition unsuccessful, not a flame, or flame detectors not feel the flame brightness, then after the safety time, security alarm system motion Kaifeng burner manufacturers, burner start work program is cut, the red light failure. When the burner has just started, such as the brightness of the flame detector Pat felt burning machine manufacturers, the security system operation, the controller does not enter the normal procedure, the solenoid valve does not open, no injection nozzle Anyang burner manufacturers, after safety time failure red light. Burner Troubleshooting: 1, put into operation A1 / A2 start oil gun. 2. Check A mill outlet air temperature is too low, the air volume is too large, otherwise adjusted. 3. A check mill outlet pressure and other parameters are normal, whether there may A1 / A2 pulverized coal pipe clogging. 4, so that the inspection on the spot inspection A1 / A2 coal combustion conditions, the existence of congestion; start checking the oil burner gun case, if there is leakage. 5, put into operation soot blowing air preheater. 6, check the total amount of wind, oxygen is normal, especially at low load air volume should not be too large, secondary air and furnace differential A side is normal. 7. A mill outage of decisions. Xuchang burner manufacturers, burner manufacturers, the sun can burn machine provided by the Shanxi Environmental Protection Equipment Co., Ltd. sun. Shanxi Environmental Protection Equipment Co., Ltd. Rising Sun (www.sxxrn.com) strong, credible, in Taiyuan, Shanxi boiler softened water treatment equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead the sun can burn your hand in the machine and into the brilliant, for a better future!