Methanol fuel burner | Rising energy and environmental protection (certified) | burner provided by the Shanxi Xinzhou Environmental Protection Equipment Co., Ltd. sun. Shanxi Environmental Protection Equipment Co., Ltd. Rising Sun (www.sxxrn.com) is specialized in the "boiler, biomass boilers, boiler burner, methanol burner" of the enterprise, the company of "honesty, hard service" concept, to provide you with The most high-quality products and services. Welcome to inquire! Contact: Zhang. When using the boiler burners, power, burning machine motor starts, ignition spark between electrodes, after about 13 seconds of pre-hair, pump solenoid valve automatically opens, mist nozzles were ignited spark breakdown the formation of a flame. At this point, feel the flame detector flame brightness, the controller enters a locked state. Ignition electrode ignition delay of about 15 seconds and then stop ignition, burner into the normal working condition. Ignition unsuccessful, not a flame, or flame detectors not feel the flame brightness, then after about 10 seconds safe time, security alarm system operation, the burner start work program is cut, the red light failure. When the burner has just started, such as the brightness of the flame detector Pat felt, the security system operation, the controller does not enter the normal procedure, the solenoid valve does not open, no fuel injection nozzle, after about 10 minutes time security, fault red bright. Therefore, in the light and be sure to cover the start-burner flame detectors, do not let it see the light until after the burner flames, instantly open flame detector, burner does not work otherwise. Burner red light after three minutes before restarting the burner. Burner commissioning a. Check the exterior of the diesel is in place alcohol burner pipe is smooth, the external power control in place. b. The load is transferred to a small combustion engine load, ignition position is adjusted accordingly small load, shut down a large load of flame ignition and observe the situation, and adjust the servo motor or throttle and fire situation according to. c. When adjusting the burner fires gas burner output, according to the device with a hot burner alcohol-based fuel loads, from a relatively small load to large load gradually adjust and adjust accordingly depending on the circumstances of the servo motor or throttle. d. Whether the bias observed flame fire, flame inadequate vibration phenomena. e. Adjust ignition several times later to observe the ignition is good.